Dryer repair in Florida usually starts with one complaint: the clothes are still damp after a full cycle. Humid air makes a dryer work longer even when it is healthy. When the vent is partly blocked, heat builds inside the cabinet and the thermal fuse blows. The dryer then tumbles cold or will not start at all.
The vent is the first thing to check. Florida residential code follows the IRC limit of 35 feet for a dryer exhaust duct, minus 5 feet for each 90 degree bend. Long runs through a garage or up to a roof cap clog fast with damp lint. The NFPA names failure to clean as the leading factor in home dryer fires. A crushed foil hose behind the dryer is a common find.
Electric dryers lose heat when the heating element, thermal fuse or high-limit thermostat fails. Gas dryers fail at the igniter, flame sensor or gas valve coils. A squeal or thump points to worn drum rollers, idler pulley or belt. A dryer that runs but will not stop may have a failed moisture sensor or timer.
Most dryer repairs are worth doing. InterNACHI lists a typical dryer life of about 13 years, longer than most washers. A fuse, belt or element is a short job on most models. A control board on an older dryer is the one repair that often tips the choice toward a new unit.
Dryer Repair Jobs covered
✓No Heat Repair
Tests and replaces elements, fuses, thermostats, igniters and gas valve coils.
✓Thermal Fuse Replacement
Replaces a blown fuse and finds the vent or airflow problem that caused it.
✓Drum, Belt and Roller Repair
Fixes squeals, thumps and drums that will not turn.
✓Vent Airflow Check
Checks the duct run, transition hose and outside hood for lint and crushing.
✓Moisture Sensor and Timer Repair
Fixes dryers that run too long or stop before clothes are dry.
✓Gas Dryer Igniter Repair
Replaces igniters, flame sensors and valve coils on gas models.
Dryer Repair Cost in Florida
| Service | Typical Range | What Affects It |
|---|---|---|
| Thermal fuse | $75 to $150 | A blown fuse often means a blocked vent |
| Belt | $100 to $250 | More with worn rollers or pulley |
| Heating element | $150 to $350 | Brand and cabinet access vary |
| Motor | $150 to $400 | Part price varies by model |
| Drum rollers | $100 to $300 | Usually replaced as a set |
| Control board | $250 to $500 | Compare with a new dryer on older units |
Ranges are typical for Florida homes. The technician gives a written estimate before any work starts.
How it works
- 1
Call with gas or electric
Say whether the dryer is gas or electric and whether it heats, tumbles or does nothing.
- 2
Diagnosis and vent check
The technician tests heat parts, the motor and drive, and checks airflow at the outside hood.
- 3
Written estimate
The price is in writing before any work starts.
- 4
Repair and heat test
The dryer runs a timed cycle while the technician checks temperature and airflow.
Pricing
Fuses and belts run low